 |
|
 |  |  |  |  |  |  |  |  |  |
|
04-22-2008, 03:15 PM
| #1 (permalink) |
 Join Date: Sep 2007
Posts: 13
Thanks: 0
Thanked 6 Times in 2 Posts
 |  Losing Sync I just got active sync 4.5 and PDAnet and it will allow me to connect but then kicks me out. I found that once the active sync finishes syncing with my Q9m it stops the connection and thus PDAnet can not connect. Any Ideas? |
|      |
| Sponsored Links |
|
04-25-2008, 05:11 PM
| #3 (permalink) |
  Join Date: Apr 2008 Location: Area 51.2
Posts: 480
Thanks: 6
Thanked 28 Times in 26 Posts
|  Keep device connected after synchronization Unfortunately since I don't have ActiveSync on my XP anymore and I just the Mobile Device Center on my Vista, I can't give you exact location. However, if you do a little digging you should find it. In your ActiveSync connection properties and settings, uncheck the box that says something to the effect of disconnect when sync is complete. It was an annoying little feature that was useless for the most part which has been phased out in MDC on Vista which replaces ActiveSync. Hope it helps and if I can find a copy of XP running ActiveSync, I will post some screenshots but in the meantime, just look for it and hopefully you find it. Good luck.
__________________ Lï£ê ï§ å Lêmðñ åñÐ Ì Wåñ† M¥ Mðñê¥ ßå¢k  -----------------------------------------------------  AT&T Motorola Q9h - Vista Ultimate AMD x64
|
|
| |
 |
| Bookmarks |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -5. The time now is 05:04 PM.